3-28 Troubleshooting
Table 3-15. System Build-UP Procedure
Step in procedure Display/Console Results Meaning
At PDC interface, set autoboot flag to
ON. Power off the SPU and remove
all assemblies except the system
board.
Install power supply, power monitor
and display panel only.
Proceeding to turn DC on
At least one processor must be installed
for PDC to take control of the boot pro-
cess
Install CPU card in CPU slot 0.
FLT 7200
No SMC available
Install memory carrier with NO
SIMMS
FLT 7500
No RAM available
Install SIMM in slot 0a on memory
carrier
FLT 7F00
Bad SIMM pair
Install SIMM in slot 0b
FLT A088
No console found
Install core I/O card.
WARN A008
No bootable device found
Install peripheral bay.
(Operating system prompt)
Boot complete
Shut down the OS. Reboot and inter-
rupt the boot process to stop at PDC.
Set the autoboot flag to OFF.
Power off the SPU and remove the
peripheral bay.
Reboot the system.
INIT C440
Initializing the stable storage console
path
Type bo pri
WARN 80F5
Cannot find ENTRY_TEST
Failed to initialize
ENRTY_INIT
Status = -7
Boot device failed
Install the peripheral bay. (PDC prompt)
Type bo pri (operating system prompt) Boot complete
To Next Page
Loading...
