Display Codes 4-13
TEST C265 Testing memory, read test
TEST C270 RE-interleaving memory
TEST C280 Configure to EEPROM
TEST C278 Configure to EEPROM
TEST C2A0 *Flat configuration
TEST C2B0 *Flat ROM configuration
TEST C2E0 Memory testing done
TEST C2C1 Memory soft reset
TEST C2C2 Memory non destructive RAM test
WARN 7800 PDT disabled warning
FLT 7800 PDT disabled halt
WARN 7801 Overwrite single bit error with multi-bit error in PDT
WARN 7802 Duplicate PDT entry
FLT 7803 EEPROM fault while updating PDT
FLT 7804 PDT table is full
FLT 7D00 Memory fault
FLT 7D01 Icache parity error in memory test
FLT 7D02 Dcache parity error in memory test
FLT 7D03 MSI read time-out (HPMC, caused by accessing beyond the end of memory or
non-responding Slave Memory Controllers)
FLT 7D04 MSI write time-out (HPMC, caused by accessing beyond the end of memory or
non-responding Slave Memory Controllers)
FLT 7D05 Processor Memory bus parity fault (HPMC)
FLT 7D06 Write bomb fault (HPMC, earlier write transaction to memory had a bus parity
error)
FLT 7D07 Memory address fault (HPMC)
FLT 7D08 Multi-bit memory fault (HPMC)
FLT 7D09 Single bit memory fault (HPMC)
FLT 7D0A Address did not map to bank (HPMC)
FLT 7Fxy x = memory carrier card number, y = SIMM pair slot number
Table 4-10. Memory Subsystem Codes (Continued)
Ostat Code Description
To Next Page
Loading...
