HP 3312A Service Manual

Model 3312A
illustrations. The figures describe the operations to be
accomplished in achieving the different modes of operation.
3-70. The operating procedure must be performed in the
2
= IBAS A FUNCTION & HedtoR i
NE RANGE åfz AANG IONS en
ofr Ode -1 : 10 00 ik 10k 360% 1M ; SW? ony dab
m mm ae om ens es m es e : ye! —
SENERE ieis ie aie ee i JE tJ LE)
hen aa OLTSUT LOFSSEICALY Ria Out Ree LET GL Dør
OF
RSE
eT
AMPLi
UDE
SYM
l,
SKAT
RANGE
He
Tit? ec, METAN RULE:
ae co
DÅ
fy a ZN
E == c jj
pi \ ae
E”
E
|
|
the i TRIGGER i MOD
E ©) SYNG PHASE aL aca SYM
Ku
GG
z,
®
/
©.
Riera GABE?
Section HHE
sequence given, as succeeding steps may depend on control
settings and results of previous steps. In all cases, it is
assumed that the main generator is set to the frequency and
amplitude desired and that al/ modulation generator func-
tion pushbuttons are in the OUT position.
. Press FM pushbutton,
2. Select a Function,
3. Set the desired deviation of frequency,
4. Set the frequency of the change.
5. SYM in CAL position.
Figure 3-9. FM Operation.
. MODULATIGN
AM Ty, Suis Ry
oog od naga
Sem gti tua QuT -4
LINE RANGE #2 SENGE ON
ofr gy : I
allel EET
is as OUTPUT | |
AMPLITUDE SYS I % ” RANGE #2
$c E A O ) VTLS
H ' wo
Ik
LUKER i Okin tu:
wt cies oe
Path
fa’ Ve 5
KJ
FØR ek
NO Å
9
FRIGGER
j SYNC PHASE
é
oo ©
FGF Nuhr
1. Set stop frequency.
2. Press SWP button,
3. Set RANGE Hz to 0,
4, Set start frequency.
5. Set RANGE Hz and VERNIER for desired repetition
rate.
6. Adjust retrace tine,
Figure 3-10. Sweep Operation.
en,

HP 3312A Specifications

General

Brand	HP
Model	3312A
Category	Inverter
Language	English