EN Chapter 6 Removing and replacing parts 179
Tray 2 paper-feed module disassembly
Remove the paper-feeder plate to gain access to the paper pickup drive assembly. It is not necessary
to separate the engine module from the paper-feed module to gain access to the paper-size
detection PCB, although it will provide easier access.
Figure 86. Removing the tray 2 paper-feeder plate
1 Separate the engine module from the paper-feed module (page 171).
2 Remove the tray from the paper-feed module.
3 Remove the four self-tapping screws (one screw is recessed in front).
4 Lift the paper-feeder plate to remove it.
5 Release the two tabs on the paper-size detection PCB cover.
6 Disconnect the three cables on the paper-size detection PCB.
7 Press the two tabs to release the paper-size detection PCB. Note the cable routing.
8 Slide the PCB from the paper-feeder frame.
9 Remove the two machine screws from the paper pickup drive assembly.
To Next Page
Loading...