180 Removing and replacing parts EN
Tray 3 and 4 paper-feed module disassembly
Remove the paper-feeder plate to gain access to the paper pickup drive assembly. It is not necessary
to remove the paper-feeder plate to access the feeder controller PCA, although it will provide easier
access.
Figure 87. Removing the paper-feeder plate
1 Lift the printer from the optional feeder.
2 Remove the tray from the paper feeder.
3 Remove the four self-tapping screws from the side rails as shown, and then lift the side rails from
the paper feeder.
4 Remove the six self-tapping screws around the paper-feeder plate (two on the left and four on
the right).
5 Remove the two machine screws and one self-tapping screw from the paper-feeder plate and the
paper pickup assembly.
6 Carefully lift the paper-feeder plate from the paper-feeder frame and the paper pickup assembly.
7 Use a flat-blade screwdriver to release the two tabs on the feeder controller PCA cover.
8 Disconnect the four connectors from the PCA. Note the cable routing.
9 Remove the single self-tapping screw from the PCA.
10 Slide the PCA from the paper-feeder frame.
Note The clutch release lever (located near the tray number) might dislodge if not careful. figure 89 and
figure 90 show detail of the lever location for reassembly.
11 Remove the paper pickup assembly.
12 Ensure the clutch release (figure 88) functions properly after the paper-feeder plate is reinstalled.
To Next Page
Loading...