68 Printer operation EN
RAM DISK=AUTO OFF
AUTO
Determine how the RAM disk is
configured. This item appears only if
there is no optional hard-disk
accessory installed and the printer has
at least 16 MB of memory.
OFF
: The RAM disk is disabled.
Configure the amount of memory to be
used through the following item:
RAM
DISK SIZE
.
Note
If the setting is changed from
OFF
to
AUTO
or from
AUTO
to
OFF
, the printer will
automatically reinitialize.
QUICK COPY
JOBS=32
0 to 50
Specifies the number of quick copy jobs
that can be stored on the printer’s hard-
disk accessory.
HELD JOB
TIMEOUT=OFF
OFF
1 HOUR
4 HOURS
1 DAY
1 WEEK
Sets the amount of time that stored
jobs are kept before being
automatically deleted from the printer.
PERSONALITY=
AUTO
AUTO
PCL
PS
Select the default printer language
(personality). Possible values are
determined by which valid languages
are installed in the printer.
Normally, you should not change the
printer language (the default is
AUTO
). If
you change it to a specific printer
language, the printer will not
automatically switch from one language
to another unless specific software
commands are sent to the printer.
Table 25. Configuration menu (continued)
Item Values Explanation
To Next Page
Loading...