HP 4284A - Page 281

TRIGger Subsystem
The TRIGger subsystem command group is used to enable a
measurementorasweep measurement, and to set the trigger mo de
and the trigger delay time. Figure 8-8 shows the command tree of
the TRIGger subsystem command group.
Figure 8-8. TRIGger Subsystem Command Tree
:IMMediate
The :IMMediate command causes the trigger to execute a
measurementorasweep measurement, regardless of the trigger state.
Refer to \Trigger System" in Chapter 7, for details.
Command Syntax
TRIGger
2
:IMMediate
3
Example
OUTPUT 717;"TRIG"
OUTPUT 717;"TRIG:IMM"
8-40 Command Reference