HP 4284A - Page 324

*ESE
The *ESE command (standard Event Status Enable command) sets
the enable bits of the standard event status register. The *ESE?
query returns the current setting of the enable bits of the event
status register.
Command Syntax
*ESE < value >
Where,
< value > NR1 format : decimal expression of enable bits of the
operation status register
The denition of each bit in the event status register is as follows.
Bit No. Description
7 Power On (PON) Bit
6 User Request (URQ) Bit
5 Command Error (CME) Bit
4 Execution Error (EXE) Bit
3 Device Dep endent Error (DDE) Bit
2 Query Error (QYE) Bit
1 Request Control (RQC) Bit
0 Op eration Complete (OPC) Bit
Example
OUTPUT 717;"*ESE 36"! Bit 2 and 5 enabled
Query Syntax
*ESE?
Query Response
Returned format is :
< value > <NL^END>
Example
10 OUTPUT 717;"*ESE?"
20 ENTER 717;A
30 PRINT A
40 END
Command Reference 8-83