HP 4284A - Page 330

*RST
The *RST command (reset command) sets the HP 4284A to its initial
settings. The initial settings set by the *RST command are given
in Appendix C. When the HP 4284A receives a *RST command,
it ab orts all pending op erations, and forgets ab out any previously
received *OPC commands and *OPC? queries.
Command Syntax
*RST
Example
OUTPUT 717;"*RST"
*TST?
The *TST? query (self-test query) causes the device to execute an
internal self-test and reports whether or not it detected an
y errors.
In the case of the HP 4284A, the resp onse to this query is alwa
ys \0"
(no error).
Query Syntax
*TST?
Query Response
Returned format is :
0<NL^END>
Where,
0 0 (NR1 format)
Example
10 OUTPUT 717;"*TST?"
20 ENTER 717;A
30 END
Command Reference 8-89