C
Initial Settings and System Memory
Introduction
This appendix lists the HP 4284A's initial settings and functions
whose status is stored in system memory.
There are three ways to initialize the HP 4284A:
POWER ON
Turn the LINE ON/OFF switch ON.
*RST
Press
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
SYSTEM RESET
in the
SYS MENU
eld of
MEAS SETUP
page, or send the
*RST
common command via HP-IB.
DEVICE CLEAR
Send the device clear bus command (SDC:selected device clear or
DCL:clears all devices) via HP-IB.
The following list indicates the dierences b etween the three
initialization metho ds on the functions to b e initialized. F
unctions
whose status are stored in internal system memory are indicated by
\Sys. Memory" on the \POWER ON" column in the following list.
Initial Settings and System Memory C-1
To Next Page
