Changing the
Measurement Range
When the measurement range frequency is set b elow 1 kHz, use the
appropriate delay time as shown b elow.
1. After changing the measurement range under the following
conditions use the delay times shown in Figure G-1.
Figure G-1. Required Delay Time After Changing the Measurement Range (1)
Note
A delay time is not required when the test signal voltage is U100
mVrms.
2. After changing the measurement range under the following
conditions, use the appropriate delay times as shown in
Figure G-2 .
Transient States Caused by Measurement Condition Changes G-3
To Next Page
