Short Circuit
Recovery
When the DUT is changed after the HP 4284A has b een unbalanced
by a shorted (or low imp edance) DUT, use a delay time as shown
below to recover from the short circuit.
1. To recover from a short circuit condition under the following
conditions, use the appropriate delay times as shown in Figure G-6
and Figure G-7.
Figure G-6. Required Delay Times For Short Circuit Reco
very (1)
Note
A delay time is unnecessary when the test signal voltage is
1Vrms,
a delay time is unnecessary.
G-8 Transient States Caused by Measurement Condition Changes
To Next Page
