HP 4400 - Page 29

Table 7 Web Tools functionality in DCFM (continued)
DCFMWeb Tools 6.1.0Function
Configure > Zoning
The Compare dialog provides the Storage-Host and
Host-Storage view in a tree representation that is
comparable to the Device Accessibility Matrix when all
devices are selected.
Zone AdminDevice accessibility matrix
Monitor > Logs > EventsMonitor > Fabric eventsFabric events
Monitor > Reports > Fabric
Summary report
Reports > Fabric summaryFabric summary
Configure > FCIP tunnelPort Admin Module, GigE tabFCIP tunnel configuration
1
Configure > FCIP tunnelPort Admin Module, GigE tabGigE ports interface
Configure > FCIP tunnelPort Admin Module, GigE tabGigE ports route
Configure > ZoningZone Admin
Admin Domain
Switch Admin > DCC policies
Performance Monitoring
2
Non-local switch ports
display in zoning tree
Configure > Zoning
Replace/Replace All zone members by selecting the
offline devices from the zone tree. Offline devices have
an unknown overlay badge with good visibility.
Zone AdminRemove offline or
inaccessible devices
Configure > Zoning
Zoning report for both online and offline database
Zone AdminZone database summary
ping
1 Viewing FCIP tunnels is supported in Web Tools 6.1.1, but New, Edit Config, and Delete are available only in DCFM.
2 In Web Tools, non-local switch port id/WWN can be added using text box.
Encryption behavior
• HP recommends that the encrypted LUN containers be created when all of the nodes/Encryption
Engines (EE) in the Data Encryption Key (DEK)/High Availability Cluster (HAC) are up and
enabled.
• If two EEs are part of a HAC, configure the host/target pair such that they form a multipath
from both EEs. Avoid connecting both host/target pairs to the same EE. This connectivity does
not provide full redundancy when EE failure results in HAC failover.
• LUN configuration
The following process is to be used then when configuring a LUN for encryption:◦
– Add the LUN as clear-text to the Crypto Target Container (CTC).
– When the LUN comes online and clear-text host I/O starts, modify the LUN from
clear-text to encrypt, including the enable_encexistingdata option to convert
the LUN from clear-text to encrypted.
◦ An exception to this LUN configuration process: if the LUN was previously encrypted by
the HP encryption switch or HP encryption blade, the LUN can be added to the Crypto
Target Container with the –encrypt and –lunstate =“encrypted” options.
◦ LUN configurations must be committed to take effect. No more than 25 LUNs can be
added or modified in a single commit operation. Attempts to commit configurations that
Encryption behavior 29