HP 46 - Page 50

3. Plug the power cord into the back of the calculator and into a
suitable power outlet. The calculator requires a maximum of 40
voltamps.
4, Turn your calculator ON by pressing the LINE switch. Each
time the HP-46 is switched-on, the word CLEAR is printed
(provided PRT OFF is released). To switch-off the calculator,
merely press LINE again so that OFF is visible.
Your calculator meets current NEMA (National Electrical Manufac-
turers’ Association) grounding standards provided that a 3-conductor
power cord is used to supply power to the calculator from a suitably
grounded outlet.
If your calculator does not operate as described above when switched
on, see Service (Appendix D).