EasyManua.ls Logo

HP 4600 - Page 64

HP 4600
244 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
50 ENWW
Setting the subnet mask
1. Press ✔ to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press ✔ to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press ✔ to select I/O.
6. Press to highlight EIO X (where X = 1, 2, or 3).
7. Press ✔ to select EIO X.
8. Press to highlight MANUAL.
9. Press ✔ to select MANUAL.
10. Press to highlight SUBNET MASK.
11. Press ✔ to select SUBNET MASK.
Note The first of three sets of numbers is highlighted. If there is not a number
highlighted, a highlighted empty underscore appears.
12. Press the or arrow to to increase or decrease the number
for configuring the subnet mask.
13. Press ✔ to move to the next set of numbers.
14. Repeat steps 12 and 13 until the correct subnet mask is entered.
15. Press the P
AUSE/RESUME button to return to the READY state.
Setting the local and default gateway
1. Press ✔ to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press ✔ to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press ✔ to select I/O.
6. Press to highlight EIO X (where X = 1, 2, or 3).
7. Press ✔ to select EIO X.
8. Press to highlight MANUAL.
9. Press ✔ to select MANUAL.
10. Press to highlight LOCAL GATEWAY or DEFAULT GATEWAY.
11. Press ✔ to select LOCAL GATEWAY or DEFAULT GATEWAY.