Table 5-13 Speaker description and part number
Description Spare part number
Speaker Kit M50412-001
Before removing theî™»speakers, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 30).
2. Remove the bottom cover (see Bottom cover and rubber feet on page 30).
3. Remove the battery (see Battery on page 32).
4. Remove the solid-state drive (see Solid-state drive on page 35).
5. Remove the WLAN module (see WLAN module on page 36).
6. Remove the fan (see Fan on page 42).
7. Remove the system board with the heat sink installed (see System board on page 46).
Remove the speakers:
1. Lift the protective tape that covers the cable between the speakers (1).
2. Use a tool to release both speakers (2). The speakers are secured with adhesive.
3. Remove the speakers from the computer (3) .
To install the speakers, reverse this procedure.
Display assembly
To remove and disassemble the display assembly, use these procedures and illustrations.
Full hinge-up displays are not available as spare parts. Spare parts for displays are available only at the
subcomponent level.
Display assembly
49
To Next Page
Loading...
