To exit the installation sequence without installing the device, follow these steps from any dialog box
where the Cancel button appears.
1. Click Cancel. A dialog box opens that prompts you with this question: “Are you sure you want to
cancel the installation?”
Figure 3-1 Are you sure you want to cancel the installation? dialog box
2. Click Yes. The Cancel dialog box opens, stating that the setup was interrupted.
Figure 3-2 Cancel dialog box
3. Click Finish to close the installation screens.
Modify a pre-existing installation
If an HP LaserJet 5200 printer has been previously installed, the appearance of the main install screen
changes on the CD Browser, and the install-printer setting changes to modify installation. A pre-
existing installation also changes the sequence of installation screens that are presented, depending
on the selections that are made.
Direct-connect installation through a USB or parallel port
The printing-system software should be installed before the HP LaserJet 5200 printer is connected to
the computer through a parallel or USB connection and turned on. During the installation process, the
software will prompt you to connect the device during installation.
58 Chapter 3 Install MS Windows printing-system components ENWW
MS Windows install
To Next Page
Loading...