ENWW System requirements 3
System requirements
In order to use the HP Embedded Web Server, you must have the following components:
● One of the following Web browsers in this list (but not limited to) installed on your computer:
● A supported Web browser. EWS-supported Web browsers include (but are not limited to) the
following:
• Konqueror 3.0 or later
• Microsoft Internet Explorer 6.0 or later
• Mozilla 1.0 (and Mozilla derivatives)
• Firefox 1.0 or later
• Netscape Navigator 6.2 or later
• Opera 7.0 or later
• Safari 1.0 or later
● A transmission control protocol/Internet protocol- (TCP/IP-) based network connection.
● An HP Jetdirect print server (embedded or enhanced input/output [EIO]) installed in the
product.
Opening the HP Embedded Web Server
Use the following procedure to open the HP Embedded Web Server.
Note You cannot view the HP Embedded Web Server screens from outside of a firewall.
1 Open a supported Web browser.
2 In the Address or Go to field, type the Internet protocol (IP) address that is assigned to the
product (for example, http://192.168.1.1) or the host name (for example, npi[XXXXXX] or a
configured host name such as http://www.[your_server].com).
If you do not know the IP address for the product, you can find it on the Configuration page. See
the user guide that came with your product to see how to print a Configuration page at the
control panel.
Login and logoff
The HP Embedded Web Server (EWS) has screens that can be used to view product information
and change configuration options. The screens that appear, and the settings on them, vary
according to how you gain access to the EWS: as a general user, an information technology (IT)
administrator, or a service provider. These passwords can be customized by an IT administrator
or a service provider.
In a password-protected HP Embedded Web Server, only the Information tab is available to
users who do not log in by using the password. If no password has been set (which is the
default), all of the tabs are visible.
If a password has been set, you must log on as an IT administrator or a service provider to gain
access to the protected HP Embedded Web Server tabs (Settings and Networking).
Note For information about changing passwords as an IT administrator, see “Security” on page 33. If
you are a service provider, see your product service guide.
To Next Page
Loading...
Need help?
General
