HP 53131A/132A 225 MHz - Page 65

Chapter 2 Command Summary
Front Panel to SCPI Command Maps
Programming Guide 2-41
Table 2-3. HP 53131A/132A *RST State (Continued)
Command Header Parameter State
*
EMC
<NRf> 0 (i.e., disabled)
:FORMat[:DATA] ASCii | REAL ASCii
:HCOPy:CONTinuous <Boolean> OFF
:INITiate:AUTO
:INITiate:CONTinuous
<Boolean>
<Boolean>
OFF
OFF
:INPut[1|2]:ATTenuation
:INPut[1|2]:COUPling
:INPut[1|2]:FILTer[:LPASs]:STATe
:INPut[1|2]:IMPedance
1 | 10
AC | DC
<Boolean>
<numeric_value> [OHM]
1
AC
OFF
1E6 OHM
[:SENSe]:EVENt[1|2]:HYSTeresis:RELative
[:SENSe]:EVENt[1|2]:LEVel[:ABSolute]:AUT
O
[:SENSe]:EVENt[1|2]:LEVel:RELative
[:SENSe]:EVENt[1|2]:LEVel:SLOPe
[:SENSe]:EVENt2:FEED
[:SENSe]:FREQuency:ARM[:STARt]:SLOPe
[:SENSe]:FREQuency:ARM[:STARt]:SOURce
[:SENSe]:FREQuency:ARM:STOP:DIGits
[:SENSe]:FREQuency:ARM:STOP:SLOPe
[:SENSe]:FREQuency:ARM:STOP:SOURce
[:SENSe]:FREQuency:ARM:STOP:TIMer
[:SENSe]:FREQuency:EXPected[1|2|3]:AUTO
[:SENSe]:FUNCtion[:ON]
[:SENSe]:PHASe:ARM[:STARt]:SLOPe
[:SENSe]:PHASe:ARM[:STARt]:SOURce
[:SENSe]:ROSCillator:EXTernal:CHECk
[:SENSe]:ROSCillator:SOURce:AUTO
<numeric_value> [PCT]
<Boolean>
<numeric_value> [PCT]
POSitive | NEGative
“INPut1 | INPut2”
POSitive | NEGative
IMMediate | EXTernal
<numeric_value>
POSitive | NEGative
IMMediate | EXTernal | TIMer | DIGits
<numeric _value> [S]
ON
<sensor_function>
POSitive | NEGative
IMMediate | EXTernal
ON | OFF | ONCE
<Boolean>
100 PCT *
ON
50 PCT
POSitive
“INPut2”
(i.e., separate mode)
POSitive
IMMediate
4
NEGative
TIMer
100E−3 S
ON
“FREQuency 1”
POSitive
IMMediate
ON
ON
________________________________
*For prior firmware revisions (3317, 3335, and 3402), *RST sets up “100%” meaning maximum
sensitivity.
For current firmware revision, *RST sets up “0%” meaning minimum
hysteresis.