Chapter 3 Programming Your Universal Counter for Remote Operation
Configuring the HP-IB
3-6 Programming Guide
To Connect the Counter to a Computer
Connect the Counter to a computer by simply installing an HP-IB cable (such as
an HP 10833A cable) between the two units as shown in Figure 3-1.
Figure 3-1. HP-IB Interconnection
Remote/Local Operation
At power-up, the Counter is under front-panel (local) control. Once in remote, the
Counter settings cannot be affected by the front-panel controls. The Save & Print
key may be used to manually return to local control (only if local-lockout is off).
To Next Page
Loading...
