190
• If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
• If the system fails to apply the configuration to an aggregation member port, it skips the port and
moves to the next member port.
Only hybrid ports support this feature. Before you use this command, assign the port to the IP
subnet-based VLAN you want to associate with.
Related commands: display ip-subnet-vlan interface.
Examples
# Associate Ethernet 1/0/1 with the IP subnet-based VLAN 3.
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] ip-subnet-vlan ip 192.168.1.0 255.255.255.0
[Sysname-vlan3] quit
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] port link-type hybrid
[Sysname-Ethernet1/0/1] port hybrid vlan 3 untagged
Please wait... Done.
[Sysname-Ethernet1/0/1] port hybrid ip-subnet-vlan vlan 3
# Associate the hybrid Layer 2 aggregate interface Bridge-Aggregation 1 with the IP subnet-based VLAN
3.
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] ip-subnet-vlan ip 192.168.1.0 255.255.255.0
[Sysname-vlan3] quit
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type hybrid
[Sysname-Bridge-Aggregation1] port hybrid vlan 3 untagged
Please wait... Done
Configuring Ethernet1/0/1... Done.
Configuring Ethernet1/0/2... Done.
Configuring Ethernet1/0/3... Done.
[Sysname-Bridge-Aggregation1] port hybrid ip-subnet-vlan vlan 3
The output shows that Ethernet 1/0/1, Ethernet 1/0/2, and Ethernet 1/0/3 are the member ports of the
aggregation group corresponding to Bridge-Aggregation 1.
To Next Page
Loading...
Need help?
General
