HP 5500 HI Series Command Reference

207
voice vlan aging
Syntax
voice vlan aging minutes
undo voice vlan aging
View
System view
Default level
2: System level
Parameters
minutes: Sets the voice VLAN aging time, in the range of 5 to 43200 minutes.
Description
Use voice vlan aging to configure the voice VLAN aging time.
Use undo voice vlan aging to restore the default.
By default, the voice VLAN aging time is 1440 minutes.
When a port in automatic voice VLAN assignment mode receives a voice packet, the system decides
whether to assign the port to the voice VLAN based on the source MAC address of the voice packet.
Upon assigning the port to the voice VLAN, the system starts the aging timer. If no voice packets are
received on the port until the aging time expires, the system automatically removes the port from the voice
VLAN. This aging time applies only to the ports in automatic voice VLAN assignment mode.
Related commands: display voice vlan state.
Examples
# Configure the voice VLAN aging time as 100 minutes.
<Sysname> system-view
[Sysname] voice vlan aging 100
voice vlan enable
Syntax
voice vlan vlan-id enable
undo voice vlan [ vlan-id ] enable
View
Layer 2 Ethernet interface view
Default level
2: System level
Parameters
vlan-id: Specifies a VLAN ID, in the range of 2 to 4096.
Description
Use voice vlan enable to enable the voice VLAN feature and configure a VLAN as the voice VLAN for the
Ethernet port.

HP 5500 HI Series Specifications

General

Brand	HP
Model	5500 HI Series
Category	Switch
Language	English