44
Examples
# Configure Ethernet 1/0/1 to block the traffic detected crossing the upper storm control threshold.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] storm-constrain control block
storm-constrain enable log
Syntax
storm-constrain enable log
undo storm-constrain enable log
View
Layer 2 Ethernet interface view
Default level
2: System level
Parameters
None
Description
Use storm-constrain enable log to enable an Ethernet interface to log storm control threshold events.
Logged events include traffic exceeding the upper threshold and traffic falling below the lower threshold
from the upper threshold.
Use undo storm-constrain enable log to disable log sending.
By default, a storm control-enabled port sends log messages when monitored traffic exceeds the upper
threshold or falls below the lower threshold from the upper threshold.
Examples
# Disable Ethernet 1/0/1 from sending out log messages upon detecting storm control threshold events.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] undo storm-constrain enable log
storm-constrain enable trap
Syntax
storm-constrain enable trap
undo storm-constrain enable trap
View
Layer 2 Ethernet interface view
Default level
2: System level
Parameters
None
To Next Page
Loading...
Need help?
General
