HP 6125G Configuration Guide

246
[SwitchB-vlan2] mld-snooping enable
[SwitchB-vlan2] quit
# Create VLAN 3, assign GigabitEthernet 1/0/3 to VLAN 3, and enable MLD snooping in the
VLAN.
[SwitchB] vlan 3
[SwitchB-vlan3] port gigabitethernet 1/0/3
[SwitchB-vlan3] mld-snooping enable
[SwitchB-vlan3] quit
# Configure GigabitEthernet 1/0/1 as a trunk port that permits packets from VLAN 2 and VLAN
3 to pass through.
[SwitchB] interface gigabitethernet 1/0/1
[SwitchB-GigabitEthernet1/0/1] port link-type trunk
[SwitchB-GigabitEthernet1/0/1] port trunk permit vlan 2 3
5. Configure Switch C in the same way as you configure Switch B. (Details not shown.)
Verifying the configuration
# Display information about the IPv6 multicast VLAN.
[SwitchA] display multicast-vlan ipv6
Total 1 IPv6 multicast-vlan(s)
IPv6 Multicast vlan 10
subvlan list:
vlan 2-5
port list:
no port
# Display the MLD snooping IPv6 multicast group information on Switch A.
[SwitchA] display mld-snooping group
Total 5 IP Group(s).
Total 5 IP Source(s).
Total 5 MAC Group(s).
Port flags: D-Dynamic port, S-Static port, C-Copy port, P-PIM port
Subvlan flags: R-Real VLAN, C-Copy VLAN
Vlan(id):2.
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Router port(s):total 0 port(s).
IP group(s):the following ip group(s) match to one mac group.
IP group address:FF1E::101
(::, FF1E::101):
Host port(s):total 1 port(s).
GE1/0/2 (D)
MAC group(s):
MAC group address:3333-0000-0101
Host port(s):total 1 port(s).
GE1/0/2
Vlan(id):3.
Total 1 IP Group(s).
Total 1 IP Source(s).

HP 6125G Specifications

General

Brand	HP
Model	6125G
Category	Switch
Language	English