Remove the optical drive:
1. Loosen the captive screw (1) that secures the memory module/wireless module compartment cover
to the computer.
2. Lift the rear edge of the memory module/wireless module compartment cover (2) up and forward
until it rests at an angle.
3.
Remove the memory module/wireless module compartment cover. The memory module/wireless
module compartment cover is available in the Plastics Kit, spare part number 646131-001.
4. Remove the Phillips PM2.5×6.0 screw (1) that secures the optical drive to the computer.
5. Insert an unbent paper clip or similar thin tool into the optical drive tab access (2) to release
the optical drive tray from the optical drive.
Component replacement procedures
45
To Next Page
Loading...
