Remove the TouchPad button board and cable:
1. Turn the top cover upside down, with the top toward you.
2.
Release the TouchPad board cable (1) and the TouchPad button board cable (2) from
the top cover. (The TouchPad board cable and the TouchPad button board cable are attached to
the top cover with double-sided tape.)
3. Remove the four Phillips PM2.0×4.0 screws (3) that secure the TouchPad button board to
the top cover.
4.
Remove the TouchPad button board (4) and cables from the top cover.
Reverse this procedure to install the TouchPad button board and cable.
Component replacement procedures
61
To Next Page
Loading...
