4. Open and log into HP Command View EVA.
5. In the Navigation pane, select the array for which you want to update hard disk drive firmware.
The Initialized Storage Systems Properties window opens.
6. Click Code load.
The Code Load Selection window opens.
Figure 21 Code Load Selection window — disk drives
.
7. Select Code Load Disk Drives On Line and click Select.
The Code Load Disk Drives On Line - Page 1 window opens.
Figure 22 Code Load Disk Drives — Page 1 window
.
8. Do one of the following:
a. If you are running HP Command View EVA 9.x or later, click Browse and navigate to the
zip file or manually enter the path to the zip file (from Step 3.a).
b. If you are running HP Command View EVA 8.x or earlier, enter the path to the folder where
you extracted the bundled image files (from Step 3.b).
HP StorageWorks Enterprise Virtual Array updating product software guide (XCS 09522000) 63
To Next Page
Loading...
