Rails with –03 brackets5.Disk enclosure1.
Two Fibre Channel copper cables6.
Eight disk drive blanks (may come pre-installed
in enclosure)
2.
Two enclosure power cords7.–04 brackets (not used)3.
Pins for round-hole cabinet conversion4.
Figure 5 Kit contents
.
Converting the rails
The rail kit supplied with the disk enclosure comes configured for square-hole racks. If you need to
convert the rails for a round-hole racks, perform the following steps:
IMPORTANT:
Do not remove the pins from the ends of the rails unless you are converting the rails for use in
round-hole racks. These load-bearing pins are designed to fit through the holes without being removed.
1. Locate the bag of eight round-hole pins included in the rail kit.
Installing disk enclosures into the expansion rack14
To Next Page
Loading...
