HP 6400/8400 - Installing the Disk Enclosure; Move Retaining Bracket to Back; Remove Bezel Cover

3. Loosen the locking nut (1, Figure 9) on the shipping retaining bracket (2) and slide the bracket
to the farthest position on the rear of the rail. This moves the bracket out of the way to let you
install the chassis in the rails.
Figure 9 Move retaining bracket to back
.
4. After attaching the rail, grab and move the rail gently to be sure it is firmly engaged in the rack
and that all latches are engaged in the rack holes.
5. Repeat Step 1 through Step 4 for the other rail.
Installing the disk enclosure
1. Remove the bezel covers from each side of the enclosure (see Figure 10).
CAUTION:
Be careful when removing the bezel covers so as to not break the locking tabs that secure the
covers to the enclosure.
Figure 10 Remove bezel cover
.
HP StorageWorks 6400/8400 Enterprise Virtual Array expansion rack reference guide 17