Figure 22 EVA6400 2C6D configuration
.
To connect the 0C6D expansion rack (with two loops and three disk enclosures per loop) to an
EVA6400 multi-product main rack:
NOTE:
After connecting one cable pair, verify every aspect of the connection before proceeding to the next
cable pair.
1. Unplug DP1-A on controller A from P1 (I/O-A) on disk enclosure 1 (S-1) and:
a. Connect DP1-A on controller A to P1 (I/O-A) on disk enclosure 7 (S-7).
b. Connect P1 (I/O-A) on disk enclosure 1 (S-1) to P2 (I/O-A) on disk enclosure 9 (S-9).
2. Complete the following verification steps:
a. Verify that the I/O module on the added disk enclosure has been assigned an index number
of the next highest enclosure number.
b. In HP Command View EVA, verify that the newly added disk enclosure is listed under the
array hardware in the Navigation pane and the I/O module displays a good operational
status.
Connecting the main rack to the expansion rack30
To Next Page
Loading...
