Figure 24 EVA8400 2C6D configuration
.
To connect the 0C6D expansion rack (with three loops and two disk enclosures per loop) to an
EVA8400 multi-product main rack:
NOTE:
After connecting one cable pair, verify every aspect of the connection before proceeding to the next
cable pair.
1. Unplug DP1-A on controller A from P1 (I/O-A) on disk enclosure 1 (S-1) and:
a. Connect DP1-A on controller A to P1 (I/O-A) on disk enclosure 7 (S-7).
b. Connect P1 (I/O-A) on disk enclosure 1 (S-1) to P2 (I/O-A) on disk enclosure 8 (S-8).
2. Complete the following verification steps:
a. Verify that the I/O module on the added disk enclosure has been assigned an index number
of the next highest enclosure number.
b. In HP Command View EVA, verify that the newly added disk enclosure is listed under the
array hardware in the Navigation pane and the I/O module displays a good operational
status.
HP StorageWorks 6400/8400 Enterprise Virtual Array expansion rack reference guide 33
To Next Page
Loading...
