HP 6400/8400 - 0 Cxd Expansion Rack Requirements; EVA8400 0 C9 D Expansion

DescriptionQuantity per 0CxDExpansion rack
components
HP EVA6400/8400 expansion rack accessory kit,
which contains:
• HP 5m Multi-mode OM3 LC/LC FC Cable (4)
• 4Gb Short Wave FC SFP+ 1 Pack (8)
• ROHS, SPOOL, Millennium Cable (4)
• Velcro, Strap 5" (8)
• Label, Cable Kit (2) - 1 blank red/green; 1
numbered red/green
Up to 2 for EVA6400
Up to 3 for EVA8400
AP712A
1
1
Use 1 AP712A per each of the first 3 disk enclosures.
Table 2 EVA8400 0C9D expansion
DescriptionQuantity per 0C9DExpansion rack com-
ponents
EVA 42U HP 10000 G2 series rack1AF002A
Power distribution unit (country specific)
2 (minimum HV)
4 (minimum LV)
252663–xxx
M6412–A FC disk enclosure9AG638B
HP EVA6400/8400 expansion rack accessory kit, which
contains:
• HP 5m Multi-mode OM3 LC/LC FC Cable (4)
• 4Gb Short Wave FC SFP+ 1 Pack (8)
• ROHS, SPOOL, Millennium Cable (4)
• Velcro, Strap 5" (8)
• Label, Cable Kit (2) - 1 blank red/green; 1 numbered
red/green
3
AP712A
1
1
Use 1 AP712A per each of the first 3 disk enclosures.
0CxD Expansion rack requirements
• One existing 2CxD main rack containing a properly wired controller pair and disk enclosures
(see Figure 1).
The controllers may be above or in the middle of the disk enclosures, depending on the number
of disk enclosures and how the rack was initially configured. Figure 1 is an example only, showing
six disk enclosures below the EVA8400 controllers.
• The main rack must be running properly.
• A new 0CxD expansion rack containing properly wired disk enclosures (see Figure 2). Figure 2
is an example only, showing six disk enclosures and assuming there are six disk enclosures in the
main rack.
Getting started8