HP 8150 - Page 193

Chapter 4 Printer Maintenance 193
Managing the Toner Cartridge
Resetting the HP TonerGauge
After a new toner cartridge is installed, the user must reset the
HP TonerGauge from the control panel. When the top cover is closed after
installing the new toner cartridge, the NEW TONER CARTRIDGE=NO message is
displayed on the control panel for approximately 30 seconds. To reset the
HP TonerGauge:
Note If the NEW TONER CARTRIDGE=NO message is no longer displayed on the
control panel, press M
ENU
repeatedly until CONFIGURATION MENU appears.
When you replace an empty or low toner cartridge, press I
TEM
repeatedly
until NEW TONER CARTRIDGE=NO appears.
1 Press - V
ALUE
+ until YES appears.
2 Press S
ELECT
to save the selection.
3 Press G
O
to exit the menu.