Chapter 5 Problem Solving 274
Correcting Output Quality Problems
Printing stops in the
middle of the job.
! Check the control panel display for an error message.
! If you are on a network, make sure the computer is
correctly configured and there is not a network problem
(see your network administrator).
! Check the line voltage to make sure that it is steady and
within printer specifications. (See page 418
.) Turn the
printer off and then back on.
! Check the time-out setting in your network application. You
might need to increase it.
! If you are trying to copy a file to the printer from the DOS
prompt, use the copy command COPY [filename] LPTn
/B printer port, such as LPT1 (where n is the port number).
Note
To output the page, you might have to send a form feed
command from the computer.
Printing is Incomplete or Incorrect (continued)
Situation Solution
To Next Page
Loading...