Chapter 5 Problem Solving 299
Correcting Output Quality Problems
A page prints with
clipped margins.
If the page margins are clipped, you may have to print the
page at 300-dpi resolution or install more memory. Also try
turning off Resource Saving and I/O Buffering.
A page fails to print. Set PRINT PS ERRORS=ON, and then send the job again to print
a PS error page. If this does not identify the problem, try
turning off Resource Saving and I/O Buffering or installing
more memory. (See page 318
for more information about PS
printing.)
A PS error page prints. ! Make sure the print job is a PS job.
! Check to see whether your software expected you to send
a setup or PS header file to the printer.
! Check the printer setup in your software application to
make sure that the printer is selected.
! Check cable connections to ensure that they are secure.
! Reduce the complexity of the graphic.
! Add available memory by turning on Resource Saving.
PS Troubleshooting (continued)
Situation Solution
To Next Page
Loading...