HP 8150 - Page 448

Appendix B Control Panel Menus 448
Configuration Menu
PCL MEMORY=
400K
0K and up
(This value
depends on
the amount of
installed
memory.)
This item appears only when RESOURCE SAVE=ON.
Select the amount of memory used for saving PCL
resources. Printer default is the minimum amount of
memory needed to perform resource saving for PCL.
Press -V
ALUE
+ to change settings by increments of
10 (up to 100 KB) or by increments of 100 (above
100 KB).
For more information, see page 476
.
PS MEMORY= 400K 0K and up
(This value
depends on
the amount of
installed
memory.)
This item appears only when RESOURCE SAVE=ON.
Select the amount of memory used for saving PS
resources. Printer default is the minimum amount of
memory needed to perform resource saving for PS.
Press -V
ALUE
+ to change settings by increments of
10 (up to 100 KB) or by increments of 100 (above
100 KB).
For more information, see page 476
.
Item Values Explanation