HP 8360 B Series - Module Select Rear; Monitor Menu

Module Select Rear
Function Group
POWER and FREQUENCY
Menu Map
2 and 5
Description
This command causes the swept signal generator to examine only
the rear panel source module interface connector to determine
the type of source module (if any) connected. The instrument
frequency limits and multiplier are altered according to the source
module connected. However, the leveling point is not changed. See
Leveling Point Module to set the swept signal generator to level
at the output of the source module.
An asterisk next to the key label indicates this feature is active.
Programming Codes
SCPI:
SYSTem:MMHead:SELect FRONtlREARlNONE
SYSTem:MMHead:SELect?
Analyzer: NONE
See Also
Module Menu
Monitor Menu
Function Group IrvlOD)
Menu Map 4
Description
This softkey (Option 002 only) accesses the menu which allows you
to output internally-generated AM and FM waveforms to the rear
panel AM/FM OUTPUT connector. It also accesses the softkeys
which allow you to display the AM depth and FM deviation of the
modulation waveforms.
ModOut On/Off AM
Outputs the AM waveform to the AM/FM
OUTPUT connector.
ModOut On/Off FM
Outputs the FM waveform to the AM/FM
OUTPUT connector.
Meter On/Off AM
Displays the AM depth of the modulating
signal.
M-26 Operating and Programming Reference