HP 8360 B Series User Manual

l CORRection:FLATness (<num>Cfreqsuffix],Cnum>[DB])2*801
l CORRection:FLATness?
Sets and queries an array of up to 801 frequency-correction
pairs. This correction information is used to create a correction
array that can be added to the internal calibration array. The
correction entered is at the associated frequency. Frequencies in
between frequency-correction pair values are determined by linear
interpolation. If a value of START or STOP frequency is specified
that is outside the limits of the specified frequencies, the correction
applied at those points is 0 dB. After *RST, returns a
MinFreq, 0 DB, MaxFreq, 0 DB response.
l CORRection:SOURce[il ARRaylFLATness
l CORRection:SOURce[il?
Sets and queries the source of correction.
l CORRection:FLATness:POINts? [MAXimumIMINimum]
Returns the number of frequency-correction pairs entered using the
CORR:FLAT command. After *RST, the value is 2.
l CORRection[:STATe] ONlOFFlllO
l CORRection[:STATe]?
Sets and queries the switch on the users ALC correction system.
The ‘RST value is OFF.
l DIAGnostics:ABUS? <num>
Reads the analog bus node number and returns the number of
millivolts.
l DIAGnostics:ABUS:AVERage <num>
l DIAGnostics:ABUS:AVERage?
Sets and queries the number of ADC averages to use during the read
ADC query. After *RST, the value is 1.
l DIAGnostics:ABUS:STATus?
Queries the status of the prior ADC reading. The response is a single
byte that is bit-encoded to mean:
Bit 0
Set to 1, if ADC timed out (hardware fault).
Bit 1
Set to 1, if reading was unsettled.
Bit 2
Set to l,if out of range occurred.
l DIAGnostics:INSTrument:PMETer:ADDRess <num>
l DIAGnostics:INSTrument:PMETer:ADDRess?
Sets and queries the HP-IB address to use for the power meter during
swept signal generator calibration routines. Allowable values are 0
S-30 Operating and Programming Reference

HP 8360 B Series Specifications

General

Brand	HP
Model	8360 B Series
Category	Portable Generator
Language	English