HP 8360 B Series User Manual

SCPI COMMAND SUMMARY
through 31. “RST or power on does not effect this value. Default is
13. It is defaulted only when memory is initialized.
l DIAGnostics:INSTrument:PRINter:ADDRess <mm>
l DIAGnostics:INSTrument:PRINter:ADDRess?
Sets the HP-IB address of the printer to use during some of the
calibration procedures when the swept signal generator assumes
HP-IB control. *RST and power on do not effect this command. The
default is 1. The default value is set at memory initialization only.
l DIAGnostics:IORW <num>,<num>
Performs a write to the I/O Device number specified in the first
<num> and sets it to the value in the second <num>.
l DIAGnostics:IORW? <mm>
Reads from the specified I/O device number and returns the response
data.
l DIAGnostics:OUTPut:FAULt?
Returns a string of 16, 1s and OS that are equivalent to the fault
display.
Bit 0 = PEAK
Bit 1 = TRACK
Bit 2 = RAMP
Bit 3 = SPAN
Bit 4 = V/GHz
Bit 5 = ADC
Bit 6 = EEROM
Bit 7 = PWRON
Bit 8 = CALCO
Bit 9 = PLLZERO
Bit 10 = PLLWAIT
Bit 11 = FNXFER
Bit 12 = CAL YO
Bit 13 = CAL MAN
Bit 14 = TMR CNFLCT
Bit 15 = SEARCH
Operating and Programming Reference S-31

HP 8360 B Series Specifications

General

Brand	HP
Model	8360 B Series
Category	Portable Generator
Language	English