49
A
Setup Instructions
Using a USB Connection
You can connect your HP DeskJet 800 Series directly to your computer using a
USB cable if your computer supports USB (Universal Serial Bus). Before you
connect your printer to your computer, make sure your configuration meets these
requirements:
•
Your computer must support USB
•
You will need a USB-compliant interface cable, such as HP Part Number C6518A
•
Your computer must be turned on and running MacOS 8.1 or higher
1 Plug in Electrical Power Cord
2 Load White Paper
a Pull out the IN tray and slide the
paper guides out as far as possible to
make room for the paper. If desired,
flip up the OUT tray for a better view
of the IN tray.
b Put a stack of paper into the IN tray,
print side down. You can insert up to
10 mm (3/8 inch) at a time.
c Push the paper toward the back of the
paper tray until it stops.
d Slide both paper guides to fit snug against the paper’s edges.
e Slide the IN tray all the way back in. If it is up, flip down the OUT tray.
6410023
6410008
To Next Page
Loading...