HP 8712ES - Page 432

9-22 ES User’s Guide
Specifications
Table 9-6 System Performance, Uncorrected, 75Ω
a. Option 1E1 adds a 60 dB step attenuator to the HP 8712ET/8714ET.
b. These numbers apply for a measurement made using the “Fine” bandwidth at an environmental temperature of
25°±5° C.
c. The uncorrected directivity of a network analyzer is calculated in linear terms by dividing the reflection measurement
of a perfect load by the average of the reflection measurements of an ideal short and an ideal open.
d. The uncorrected source match is the source match of the network analyzer when making a ratioed, uncalibrated mea-
surement.
e. The uncorrected load match is the match of the network analyzer port used on the load side of a measurement.
f. Measured by setting output power to the maximum specified setting, connecting shorts to both ports, and measuring
transmission. Typical and specified crosstalk values are 5 dB worse than those shown in the table below 1 MHz (for all
models) and above 2.2 GHz (for 8714ET/ES models).
HP 8712ET/ES and HP 8714ET/ES (75 Ω)
Description HP 8712ES/8714ES
HP 8712ET/8714ET
with Attenuator
Option 1E1
a
HP 8712ET/8714ET
(without Attenuator)
300 kHz
to 1.3 GHz
1.3 GHz
to 3 GHz
300 kHz
to 1.3 GHz
1.3 GHz
to 3 GHz
300 kHz
to 1.3 GHz
1.3 GHz
to 3 GHz
Specification
b
(in dB)
Directivity
c
27 19 27 19 27 18
Source Match (Ratio)
d
18 15 21 15 23 19
Load Match
e
18 15 18 15 18 15
Crosstalk
f
88 88 97 97 97 97
Typical
b
(in dB)
Directivity 40 30 40 30 40 30
Source Match (Ratio) 23 20 24 20 28 23
Load Match 24 22 24 22 24 22
Reflection Tracking
±1.5 ±1.5 ±1.0 ±1.5 ±1.0 ±1.0
Transmission Tracking
±1.5 ±1.5 ±1.5 ±1.5 ±1.0 ±1.0
Crosstalk
f
95 95 105 105 105 105