able
l-11.
HP-II3
Only Commands (continued)
Action Mnemonic S ?
Description
OUTPUT (continued)
ril
report
OUTPFAIP*
1
This command is similar to OUTPLIMF except
that it reports the number of failures first,
followed by the stimulus and trace values for
each failed point in the test.
xmatted
OUTPFORM
1
Outputs the formatted trace data from the
active channel in current display units. See
‘lhble
1-4 for data transferred.
OUTPFORF
1
Fast data transfer command for OUTPFORM.
Only the first number of the OUTPFORM data
pairs is transferred. See
‘lhble
1-4.
&m-p.
cal.
OUTPICAL< I> 2
Outputs the selected interpolated cal coefficienl
*IT*y.
lentify
OUTPIDEN
1
See IDN?
lstrument
3wer meter OUTPIPMCAL<I> 2
Il.
ey code
OUTPKEY
1
Outputs the interpolated power meter cal array
for channel 1 or channel 2.
Outputs the code of the last key pressed, in
ASCII format. See Figure l-6 for key codes.
-
1
is transmitted for a knob turn.
earn string
OUTPLEAS
1
Outputs the learn string in binary, not intended
for decoding.
imit test:
OUTPLIMl
*
1
Outputs status5 of limit test for channel 1.
31
imit test:
OUTPLIM2’
1
Outputs
status.5
of limit test for channel 2.
n2
imit test:
OUTPLIMS’
1
Outputs
status3
of limit test for channel 3.
h3
imit test:
OUTPLIM4
* 1
Outputs
status5
of limit test for channel 4.
h4
imit
lilures
OUTPLIMF
1
Outputs the limit results as described under
OUTPLIML for only those stimulus points that
failed.
Refer to the “Limit Line and Data Point Special Functions” section in HP
ESASIC
sogrammingExamplesc;uide.
Values returned for limit test status are: 1 (PASS), 0 (FAIL),
-
1
(NO-LIMIT)
l-98
HP-IB
Programnu
‘ng and Command Reference Guide
To Next Page
Loading...
