LIMILINE<ONIOFF>
Turns the display of the limit lines ON and
OFF.
LIMIMAOF
Marker to limit offset. Centers the limit
lines about the current marker position
using the limit amplitude offset function.
LIMISTIO[D]
Enters the stimulus offset of the limit
lines. Range: stimulus range.
LIMITEST<ONIOFF>
Turns limit testing ON and OFF.
These 8 commands edit a limit test segment. The limit table editing is
begun with ED I TL I
ML
;
, and a segment is brought up for editing with
SEC:11
Hi
or added using
SHDDj.
The segment is closed with
SDOH
j
,
the table is closed with
ED
I
TDOHE;
.
=Wl
-WY
=Wl
=v1
LIMTFL
LIMTSL
LIMTSP
-UPI
Sets the limit delta value while
editing a limit line segment.
Range: amplitude range.
Sets the lower limit value. Range:
amplitude range.
Sets the middle limit value. Range:
amplitude range.
Sets the limit stimulus break point. Range:
stimutus range.
Makes the segment a flat line.
Makes the segment a sloping line.
Makes the segment a single point.
Sets the upper limit value. Range:
amplitude range.
Selects a linear frequency sweep.
Selects the linear magnitude display
format.
LINTDATA[D]
Enters the line type for plotting data.
Range: 0 to 10.
LINTMEMO[D]
Enters the line type for plotting memory.
Range: 0 to 10.
LISFREQ
Selects the list frequency sweep mode.
l-
124
HP-IB Programming and Command Reference Guide
To Next Page
Loading...
