LISIFBWM<ONIOFF>
LISPWRM<ONIOFF>
LISV
Enables/disables the IFBW setting for a
list-frequency table in swept list mode.
Enables/disables the power setting for a
list-frequency table in swept list mode.
Selects either the stepped list mode
or the swept list mode to use with a
list-frequency table.
Activates the list values function.
The next page of values can be called
with
HEXP;
and the previous page can
be called with PREP; . The current
page can be plotted or printed, in
raster graphics mode, with F'LUT; , or
PI?
I
tVlLL
;
respectively. The entire list
can be printed, in ASCII text mode, with
PR
I
HTALL;
. (Since these commands
may need to take control of an HP-IB
peripheral, the system controller must
have pass control capability.)
These 5 commands load the file from disk with the name indicated by
the previous TITFn command. The actual file loaded depends on the file
title in the file position specified by the TITFn command. Requires pass
control mode.
LOAD1
Loads the file from disk using the file
name provided by the preceding T I TF 1
j
command.
LOAD2
Loads the file from disk using the file
name provided by the preceding T I TFZ
r
command.
LOAD3
Loads the file from disk using the file
name provided by the preceding T I TF3
;
command.
LOAD4
Loads the file from disk using the file
name provided by the preceding T I TF4
j
command.
LOAD5
Loads the file from disk using the file
name provided by the preceding T I TF5
g
command.
HP-IB Programmi
ng and Command Reference Guide
1-125
To Next Page
Loading...
