HP 8753E - Page 133

LOADSEQ<I>
LOAN
LOAO
LOCONT<ONIOFF>
LOFREQ[D]
LOFSTAR[D]
LQFSTOP[D]
LOFSWE
LOGFREQ
LOGM
LOOC[D ]
LOPOWER[D]
LOPSTAR[D]
LOPSTOP[D]
LOPSWE
LOWPIMPU
LOWPSTEP
LRN?
IJwY
Loads the file from disk with the name
indicated by the previous TITSEQn
command. The actual file loaded depends
on the file title in the file position
specified in the TlTSEQn command.
Requires pass control mode. Range: 1 to 6.
Measures the load as not being offset
when a standard has been defined as an
offset load (see OFLS).
Measures the load as being offset when
a standard has been defined as an offset
load (see OFLS).
Turns external LO control on/off.
Sets the LO frequency.
Range: ji-equenc?J range of instrument.
Sets the LO start frequency.
Range: fi-equencp range of instrument.
Sets the LO stop frequency.
Range: j+-equenc?J range of instrument.
Selects the LO sweep frequency mode.
Selects a log frequency sweep.
Selects the log magnitude display format.
Sets the value of the sequencing loop
counter. Range: 0 to 32,760.
Sets the LO power level.
Range: power range of instrument.
Sets the LO start power level.
Range: power range of instrument.
Sets the LO stop power level.
Range: power range of instrument.
Selects sweep power mode.
Turns ON the low pass impulse transform.
Turns ON the low pass step transform.
Same as OUTPLEAS (output lean string).
Same as INPULEAS (input learn string).
1-126 HP-IB Progranuui
ng and Command Reference Guide