HP 9000 300 Series - Page 37

9 Make other SCSI interface
feature value changes as
needed. When you are finished,
you can:
• Select another interface to
reconfigure by typing:
® (Return J/(Enter J
from the SCSI menu.
• Store new interface values in
the
EEPROM by typing:
® (Return J/(Enter)
from the Configurable
Interfaces menu.
Then the
Configuration Control menu
will appear.
SCSI
Key
Feature Value
1 Select Code 14
2 Interrupt Level 3
3
Parity Y
4 Bus Address 7
X to eXit menu
Type
[key] RETURN ?
Configuring Internal Interfaces and Boot Modes 3-7
3