Chapter 6
Removing and Replacing Components
Removing and Replacing Server Covers and Bezel
155
Removing and Replacing the Front Bezel on a Rack-Mounted Server
You must remove the front bezel from the chassis to gain access to the power supplies and optical drive.
Removing the Front Bezel
Step 1. Press in on the retaining clips located on the right-side of the front panel.
Figure 6-7 Front Bezel Retaining Clip
Step 2. Rotate the front panel outward and lift it off the server chassis.
Replacing the Front Bezel
Step 1. Insert the bezel latches into the matching slots on the server chassis.
To Next Page
Loading...
