Chapter 6
Removing and Replacing Components
Removing and Replacing Server Covers and Bezel
158
c. Slide the top cover toward the back of the chassis and lift it off.
CAUTION The server depends on the access panels being closed for proper cooling of internal
components. Operating the server with the side cover removed can cause the server
to quickly overheat.
Replacing the Top and Side Covers on a Pedestal-Mounted Server
CAUTION Secure any wires or cables in your server so they do not get cut or interfere with the
replacement of the cover.
Step 4. Replace the top cover:
a. Align the front edge of the top cover with the alignment mark on the optical drive bay.
Figure 6-11 Top Cover Alignment Mark
To replace cover,
align front edge here
then slide forward
To Next Page
Loading...
