HP 9000 rp3410 - Figure 6-44 Unlocking the Dual Processor Module Locking Mechanism

Chapter 6
Removing and Replacing Components
Removing and Replacing a Dual Processor Module
191
Step 4. Unlock the dual processor module locking mechanism using the CPU install tool. Insert the tool
into the hole that runs down through the edge of the heatsink and rotate the special processor tool
180 degrees counterclockwise. Verify that the dual processor module socket locking mechanism is
rotated into the unlocked position (Figure 6-44).
Figure 6-44 Unlocking the Dual Processor Module Locking Mechanism
Step 5. Remove any protective packaging from the processor modules.
NOTE Protective covers can be installed to protect connector pins. The covers can be saved
for future use.
CPU Install Tool
(2.5 mm Driver or
Allen Wrench)