HP 9000 rp3410 - Figure 6-51 Routing the Turbofan Power Cables through the Heatsink Posts; Figure 6-52 Connecting the Power Pod Cable

Chapter 6
Removing and Replacing Components
Removing and Replacing a Dual Processor Module
197
Step 13. Route the turbo fan power cables through the heatsink posts so the cables will not be pinched when
the processor airflow guide is set in place (Figure 6-51).
Figure 6-51 Routing the Turbofan Power Cables through the Heatsink Posts
Step 14. Connect the turbo fan power cable to the system board.
Step 15. Connect the power pod cable to the power connector on the system board.
Figure 6-52 Connecting the Power Pod Cable
Step 16. Replace the processor airflow guide. (See “Replacing the Processor Airflow Guide” on page 175.)
Step 17. Replace the memory airflow guide. (See “Replacing the Memory Airflow Guide” on page 172.)
Step 18. Replace the cover.